2026-07-072026-07-07http://salesiana.dossiersoluciones.com/handle/123456789/141700Conventional drop-weight techniques were modified to accommodate low-amplitude force transducer signals from low-strength, cold isostatically pressed 'heavy' composites of polytetrafluoroethylene, aluminum and tungsten. The failure strength, strain and the post-critical behavior of failed samples were measured for samples of different porosity and tungsten grain size. Unusual phenomenon of significantly higher strength (55 MPa) of porous composites (density 5.9 g/cc) with small W particles (less than 1 micron) in comparison with strength (32 MPa) of dense composites (7.1 g/cc) with larger W particles (44 microns) at the same volume content of components was observed. This is attributed to force chains created by a network of small W particles. Interrupted tests at different levels of strain revealed the mechanisms of fracture under dynamic compression.4 pages, 6 figures, paper is in press in Proceedings of the Conference of the American Physical Society Topical Group on Shock Compression of Condensed Matter, American Institute of Physics,2008Soft Condensed MatterMaterials Sciencetext